Your cart is empty

AS 1001-1970 Plain setting rings for internal measuring equipmen

$33.80
Plain setting rings for internal measuring equipment (metric series)

PREFACE
This Australian standard was prepared by the SAA Committee on Metrology. It has
been based largely on BS 4064:1966.
This standard covers a rationalized metric series of plain setting rings and, unlike
BS 4064, does not represent a conversion from the inch series given in BS 4065. The
length of larger rings has been limited to 25 mm, and certain outside diameters have
been reduced. The minimum hardness has been increased from 59 HRC to 62 HRC
(from 750 HV to 780 HV), and the recommendations with regard to stabilizing have
been expanded by providing an alternative method to that of BS 4064.
Inch series plain setting rings are specified in AS B294.
This standard requires reference to the following Australian standards:
B84 Method for Rockwell Hardness Test
B106 Vickers Hardness Test
B131 Centre-line-average Height Method (M-system) for the Assessment of
Departures from Roundness
B219 Methods for the Assessment of Departure from Roundness.

Add to Cart:

  • 1000 Units in Stock


This product was added to our catalog on Friday 21 September, 2012.

walitefree