Your cart is empty

AS 1055.2-1997 Acoustics - Description and measurement of enviro

$27.43
Acoustics - Description and measurement of environmental noise - Application to specific situations 11 pages

PREFACE
This Standard was prepared by the Joint Standards Australia/Standards New Zealand
Committee AV/5 on Acoustics, Community Noise, to supersede AS 1055.2?1989,
Acoustics?Description and measurement of environmental noise, Part 2: Application to
specific situations . This Standard is based on I.S.O. 1996-3:1987, Acoustics?Description
and measurement of environmental noise?Part 3: Application to noise limits. This
Standard is a result of a consensus among representatives on the Joint Committee to
produce it as an Australian Standard. New Zealand has proceeded with a separate review
of its environmental noise Standard NZS 6802:1991.
It is Part 2 in a series of Standards on the measurement and assessment of environmental
noise. The objective of this Part is to provide guidelines for setting noise limits and
describes procedures for checking compliance with such limits and for investigations of
specific environmental noise situations. It is assumed that noise limits are established by
relevant authorities according to these guidelines and may be embodied in Noise Limit
Requirement documents, to which references are made.
This Standards is not a regulatory document and users should ascertain, from the relevant
regulatory authority, details of specific requirements laid down in each State or Territory.
The term ?informative? has been used in this Standard to define the application of the
appendix to which it applies. An ?informative? appendix is only for information and
guidance.
{

Add to Cart:

  • 1000 Units in Stock


This product was added to our catalog on Wednesday 26 September, 2012.

walitefree